Amplificador ONKYO A-924

110V

Rating of a mode

Form Integrated Amplifier

Output power

(20Hz – 20kHz, 0.08%) 45W+45W (6ohm)

40W+40W (8ohm)

Practical use maximum output 80Wx2 (EIAJ, 4ohm)

THD 0.08% (at the time of a compact disk->SP Out Output power)

Frequency characteristic 15Hz – 50000Hz, �}1dB

S/N ratio (at the time of an Output power) 102dB (compact disk->SP out)

Power consumption (Electrical Appliance and Material Control Law) 110W

Dimensions Width 435x height 120x depth of 331mm

Weight 6.7kg

Description�@

The Integrated Amplifier developed based on the “clean grand thought” which thinks the stability of grounding potential as important paying attention to the dynamic behavior and the dynamic performance of amplifier.

The stonewalling by a ground loop was solved by designing based on clean grand thought, and tone qualities, such as a feeling of sound field, S/N, and low-pass, are improved.

The discrete amplifier which arranges and constitutes component partses, such as a transistor, a resistor, a capacitor, on a substrate separately, respectively is adopted. Thereby, the freedom of a design contributes compared with what was IC-ized by one package for a tone quality to elaborate greatly.

Moreover, in order to expand the width of a selection of a speaker, strengthening of a power-source part, and low-impedance-izing and wide-range-izing of the power amplifier part are performed.

It is made from wide-band-izing and the basic design of low NFB (negative feedback).

Moreover, the direct signal construction which shortens a signal path is adopted.

The system control remote control which can operate T-424, C-724, etc. collectively is attached.

A Source-Direct circuitry, the loudness switchpoint, the phone equalizer corresponding to man-month cartridge, the tapes value monitor, the tone control, etc. are carried.

The two screw type speaker terminal corresponding to a banana plug is adopted.

The polar attached-indicator power cord is adopted.